Lab 8:  Diodes:  Clippers, Clamps, Shifters, and Rectifiers

In this lab you will use the function generator and the oscilloscope to measure the voltages waveforms of various diode circuits. 

 

In order to do this lab you need to understand the characteristics of diodes and zener diodes

 

Reading  Ch 4.1-2, 5.3 + lecture notes. 

Function generator set up.  Connect the function generator to your circuit.  Use a BNC Tee to also connect the function generator to channel 2 of your scope.  Set the function generator to output a 100 Hz sine wave with a 2 Vp-p amplitude and zero DC offset.  Use the sync signal from the function generator for the external trigger of the scope as you have done before.

Oscilloscope probes.  Obtain a 1X or 10X scope probe and connect it to channel 1. 

Scope set up.  Set up the scope so you can see the traces of both channels.  Connect the probe to Vin.  Verify that this voltage is and should be the same as observed in channel 2.  Be sure to DC couple both oscilloscope channels!

Text Box: Figure credit: Hayes & Horowitz, Student Manual for the Art of Electronics, Cambridge Univ. Press, 1989.

Construct the following circuits on the bread board.  Compare the input waveform to the output waveform.  Make a sketch in your lab notebook.  These circuits behave differently in different regions of Vin.  Your sketch should show these features and identify the effects of Vf and Vr where appropriate.  The following is an example.  Note the 9.4 V is Vin – Vf and that –0.6 V is –Vf.

Your lab report will consist of

1) sketches of the circuits and the corresponding sketches of Vin and Vout (similar to that shown above),         
2) Identify the function of the circuit according to the descriptions in the lecture handout,     
3) answer the questions pertaining to circuits H and I, and        
4) your yellow notebook pages.


Components:  In the following circuits, normal diodes are 1N4148, zener diodes are 1N4733, R = 10K, C = 1 μF.

For circuit H, what is the significance of the time constant τ?  If you want to use H as a peak detector, what factors will guide to in selecting τ?

For circuits H and I, R = 1 M.

 

 

LEDs are a type of normal diode.  They are usually connected to a DC power supply in series with a resistor.  The purpose of the resistor is to limit the current through the diode. 

A) Find the equation for R in terms of V, Vf, and If. 

B) Calculate the value of R necessary if V = +6 V and the specification of the LED is Vf = 2.2 V and If = 10 ma.